联系电话:13292436688

河北贝卡纤维制造有限公司
电话:13292436688
联系人:刘淑贤
地址:河北唐山玉田杨家套
网址:www.gangxianwei51.com
当前位置:有关钢纤维的投料要求有哪些?
有关钢纤维的投料要求有哪些?
[来源:http://www.gangxianwei51.com] [作者:liumiao] [日期:22-04-19] [浏览次数:]

有关钢纤维的投料要求有哪些?我们就给大家整理出来分享给大家:
What are the feeding requirements for steel fiber? We'll sort it out and share it with you:
1、现将钢纤维及粗骨料投入拌和机拌30秒,使钢纤维分散在石子中。
1. Now put the steel fiber and coarse aggregate into the mixer for 30 seconds to disperse the steel fiber in the stone.
2、再将砂及水泥投入拌和机干搅拌30秒。
2. Then put the sand and cement into the mixer for dry mixing for 30 seconds.
3、再在转动着搅拌机中加水,并再搅拌3分钟左右。
3. Add water in the rotating mixer and stir for about 3 minutes.
压实:钢纤维混凝土浇注时,随拌随用,连续浇捣,不到分格缝不得甩施工缝,浇捣时应振密实。
Compaction: when pouring steel fiber concrete, it shall be mixed and used at the same time. It shall be poured and vibrated continuously. The construction joint shall not be thrown until it reaches the division joint. It shall be vibrated and compacted during pouring and vibrating.
抹面压纹:钢纤维混凝土具有集粗料细,砂率大,纤维乱向分布的特点。采用机械抹平,阻止纤维外露。采用压纹器工艺还应以避免拉毛产生纤维外露现象,经24小时后,应按常规及时养护
Plastering and embossing: steel fiber reinforced concrete has the characteristics of fine aggregate, high sand rate and random distribution of fibers. Mechanical troweling shall be adopted to prevent fiber exposure. The embosser process shall also be adopted to avoid fiber exposure caused by galling. After 24 hours, it shall be cured in time according to the routine

版权 © 河北贝卡纤维制造有限公司 网址:www.gangxianwei51.com 尼龙输送带 河北立体车库 防撞墙模具 大棚遮阳网 麻绳 华尔街铜牛 报警器塑料外壳 淤泥固化设备
保定网站优化保定网络公司